Pool Installation Benefits When Using Wall Foam

When installing an above ground pool there are a few pool installation aides that help not only make the pool installation process a little easier, but protect the pools components as well. Wall foam, Foam Pool Cove and Liner Armor Floor Pad are all great installation aids and are available through at The Pool Factory.

Pool Installation Products – Wall Foam

Each pool installation product has its benefits but Wall Foam specifically has some special qualities. The most popular size for above ground pool Wall Foam is 1/8” thick and 48” high.

It is available in rolls of 60’, 85’, 105’ and 125’ lengths. The amount needed will vary based on the total circumference of your pool.

Installation of the Wall Foam

Once the wall has been erected you may begin to apply the wall foam. It is highly recommended to use Gladon Foam Bond Spray Adhesive and doing so will make the installation of the wall foam dramatically easier.

Begin by spraying a small section of the wall (you can also spray the wall foam as well to make sure a solid bond is created).

When the Foam Bond becomes tacky begin to apply the wall foam as near to the top of the wall as possible. There are two reasons for this; one being that the wall, even at its highest point, will be protected since the bottom will be covered with either a sand or a foam pool cove. Second, the straight line of the pool wall will assist in installing the wall foam evenly as it will be easy to keep the spacing consistent. Continue to work in manageable sections until the entire circumference is covered. If there is excess wall foam left over, cut and discard the remainder. Once completely adhered, continue with the liner installation process.

Benefits of Wall Foam

Since the vinyl pool liner is one of the softest and most vital parts of an above ground pool, wall foam is important because it adds an extra layer of protection between the liner and metal components of the pool. It can protect against punctures from the wall bolts or any other sharp edges of the pool wall or pool components and should be considered before pool installation.

Wall foam can add softness once the pool has been installed but for the most part will not make a dramatic difference in regards to feel. It is thick enough only to be a protectant. The softness does help though in regards to cushioning something sharp from the inside. For example, if a toenail were to push against the wall, it is less likely to cut the vinyl pool liner with the wall foam as a damper. Without the wall foam, the hard surface of the wall could make it easier for something sharp to effect the liner.

Overall, with the ease of installation and its inexpensive price, Wall Foam is a simple way to improve the overall quality of your above ground pool and provide added peace of mind.